The Club Jameco Whiteboard is a collaborative discussion board where thinkers and makers meet to help each other with electronic projects. Get Ideas...Get Help...Get Connected.
Results 1 to 3 of 3

Thread: Replace LED in third brake light

  1. #1

    Question Replace LED in third brake light

    Our Ford Freestar recently had its annual state-mandated inspection. The (overzealous?) mechanic failed the third brake light (it has a series of 9 red LEDs). I didn't speak directly with the mechanic (yet) and the only "problem" I see is that one of the LEDs doesn't light up when braking and one next to it is dim. Overall, the light is highly visible when braking. I disconnected both the unlit and dim LEDs from the assembly. Interestingly, if I use the LED that appeared dim to connect the posts on a 9v battery, it lights up and appears very bright. The "dead" LED doesn't light up at all.
    Rather than $150 to have the mechanic replace the light assembly, I'm leaning towards picking up a through-hole LED and connecting/soldering it in place. I have rudimentary electronics and soldering experience/ability. Any suggestions or things to look out for? Do I need to worry about voltage requirements for a replacement LED? If you can point me to a good choice for replacement LED, perhaps (nearly) identical to the LEDs in my assembly, it would be appreciated.



    Last edited by regexaurus; 03-19-2016 at 01:26 PM.

  2. #2

  3. #3
    Right! Ideally you described it all, that was it!
    more

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •